Having a working windshield washer is one of the things you shouldn’t do without. First of all, we think of driving comfort, but it is necessary to know that this also means your security at the wheel because of the importance of field of vision when driving your Mazda 5.
In this article we will make clear step by step how to identify the fault and solve it in order to have an effective windscreen washer.
Identify the failure of the windscreen washer of your Mazda 5:
First thing to watch out for before handling, have you filled up your cleaning fluid? If so, let’s see what causes prevent your equipment from operating properly.

wipers-not-workingmazda-5

Causes for wipers that no longer work on your Mazda 5

Very often, your equipment is obstructed by accumulated dirt or limescale. This is the main factor that will prevent your equipment from working. To remedy this, try to unclog your sprinklers. These holes allow the product to be propelled onto your Mazda 5’s windshield. It is very likely that they are clogged, by accumulation of limestone, or various types of dirt. To do this, you can start by trying to blow, yourself or with some efficient equipment, such as a bicycle pump or preferably the tire inflator at your gas station.

How to fix wipers that no longer work

If nothing can be done, try to get yourself a thin, durable thing, such as a paper clip, that will allow you to gain access to the interior without losing a piece. We advise that you also employ a mixture of vinegar and hot water to optimize your results.
Repeat the test, if it still doesn’t work, maybe it’s obstructed at a deeper place, at the connection pipe. This is the link between the pump and the nozzle in your Mazda 5.
To reach it, you will have to open your cover:
You should find the two hoses specific to each nozzle. Try to clean them and obviously make sure they are properly connected. Use the same cleaning procedures described above. When they are cleaned, you should be able to circulate water through them without any problems. Then plug them back in correctly, and repeat the test on your Mazda 5. If it still doesn’t work, you now know that it doesn’t come from the sprinklers or the pipes.
After that, you should then check the pump. It is the one who sets out the product launch.
You will find it near the cleaning fluid reservoir under your Mazda 5’s hood.
First test to see if it works, when you turn on the washer, you are meant to hear a noise when the pump is activated. In the absence of noise, this means that it does not work. It will then have to be replaced.
It is a very basic thing to do . First, take out the two screws that allow it to be fixed on your Mazda 5.
Then, you must find two power wires. They are mainly black and red. They must be disconnected, but be aware, they must be reconnected in the right direction afterwards, or you could create a short circuit on your Mazda 5. A little tip to bear in mind: the red wire symbolizes the + terminal. For example, put a piece of red tape on it to make sure you can find it. Do the same with the black tape on the bollard – . Thanks to this, you should be able to reconnect the wire of the right color without any difficulty later on.
Once completed, you can do away with the old pump and insert the new pump on your Mazda 5. Reconnect the cables correctly using the tip, then just screw the two retaining screws back on.
Now run a test again.
Everything should be back to normal by now.

To discover more tips on the Mazda 5, take a look at the Mazda 5 category.